Thin Cylinder

Product Features: Stainless Steel

Type: Thin Cylinder

Action Mode: Impact Air

Bore: 0.58mm

Standard Stroke: 3.55mm

Number of Cylinders: 12

Theoretical Force: 21N

Port Diameter: 1.2mm

Temperature Range: 0-35°C

Applicable Pressure: 1500

Port Thread: Deep Thread

Speed Range: 100

Specification: Standard

The pushing and pulling force of the piston rod is determined by the force required for the work. Therefore, when selecting a cylinder, a certain margin should be allowed for the cylinder output. If the selected bore is too small and the output power is insufficient, the cylinder cannot work normally; however, if the bore is too large, not only will the equipment be bulky and costly, but gas consumption will also increase, causing energy waste. To reduce the cylinder volume, a force-amplifying mechanism should be used as much as possible in fixture design.

① Single-acting cylinder: It has a piston rod at only one end; one side is filled with compressed air, and under pressure the piston extends with a thrust, then returns by spring or gravity.

② Double-acting cylinder: Air is supplied alternately to both sides of the piston, enabling output in one or both directions.

③ Diaphragm cylinder: Uses a diaphragm instead of a piston, outputs force in only one direction, and resets by spring. It has good sealing but a short stroke.

④ Magnetic couple rodless cylinder: It is a component that converts the pressure energy of compressed gas into the kinetic energy of the piston (10-20 m/s) and uses it as power. The impact cylinder adds an intermediate cover with a nozzle and an exhaust port. The middle cover and piston divide the cylinder into three chambers: air storage chamber, head chamber, and tail chamber. Suitable for blanking, punching, crushing, and forming. A cylinder that performs reciprocating swing is called a swing cylinder; a blade divides the cylinder into two parts, air is alternately supplied to the two cavities, and the output shaft swings about 280°. In addition, there are rotary cylinders, pneumatic-hydraulic damping cylinders, step cylinders, etc.