How to install the two-position two-way solenoid valve correctly without error?

Two-position two-way solenoid valve in the pump to stop running or cut off the switch, the valve can also be additionally closed to avoid pollution of the environment, but such a valve is not suitable for all occasions, mainly in the gas or non-corrosive gas, the correct installation and use of machinery and equipment, not only to improve the efficiency of the work, but also to extend the life, then, how should the correct installation of two-position two-way solenoid valve?

1、Before construction

Before installation, please read the instruction manual carefully, see how it is used, see how it is used, know the installation points of the two-position two-way solenoid valve for water, make adequate preparations, in the installation of the whole process, to ensure that the orientation of the magnet coil is upward, but also to maintain the vertical position, the inflow of the pipe should be consistent with the logo on the solenoid valve.

2、In the process of installation

If it is in the low-lying areas of the pipeline, condensate, sediment, etc. will move inside the valve, thus affecting the work, high pressure two-position two-way solenoid valve if in the installation if the pipeline stiffness is not enough, you can also use the support frame to fix the high pressure solenoid valve does not move the pipeline up and down, to ensure the stability of mechanical equipment at work.

3、After the installation is completed

Solenoid valve must work in a clean natural environment, so after the installation is complete, everyone should fully clean the pipeline, remove the residual rubber seal, and set a filter in front of the solenoid valve to stop the flow of sediment into the valve, in addition, the filter system will be cleaned in a timely manner.

According to the installation of vacuum solenoid valve, the pipeline can be vacuum pumping, pneumatic two-position two-way solenoid valve will have a great impact on the working condition of the system, and can also be remotely controlled by electromagnetic induction device, this time there is a faster way to ensure the safety of the pipeline, and there are many types of this solenoid valve, but also very practical, so we can choose a more economical according to their needs model.