MCHA-20 ari gripper finger cylinder

Installation and application.

1, in sudden conditions, when the circuit pressure is low, the clamping force of the finger cylinder metal joint is reduced and the workpiece falls, install anti-fall equipment.

2, do not use the pneumatic finger under external force and impact.

3, single-action type in the case of only elasticity, please consult with our company.

4、When installing and mounting the pneumatic finger, be careful not to let it fall, collision and damage.

5、When fixing the caliper, do not twist the caliper.

6、The blowing machine finger cylinder has the following installation methods, the torque of the fixing screw should be within the torque range listed in the following table.

Bad rotation and too much rotation will lead to positioning and dropping.

7, the installation method of caliper accessories: be extra careful when installing caliper accessories, only use open-end wrench to clamp the caliper in, then use the hexagonal wrench to fix the screw, do not fix the screw on the main body, so as not to cause damage to the parts.

8, small finger cylinder to confirm that there is no external force attached to the pliers. A lateral load is applied to the clamp, generating a shock load that causes the clamp to shake and damage. Set the gap to prevent the pneumatic finger from colliding with the workpiece and accessories at the end of the stroke.