Which need to pay attention to the installation of stainless steel one-way solenoid valve matters

In the use of stainless steel one-way solenoid valve, but also pay attention to the installation of one-way solenoid valve, but also take into account the office temperature, working pressure, etc.. Stainless steel high pressure valve wholesale products in the daily work of its maintenance in the normal course of use is very important.

(1) before installation, please read the instructions carefully to ensure that the product meets the actual safety standards, if they are stainless steel two-position two-way solenoid valve, it is recommended that the application company to arrange an employee to handle the program maintenance.

(2) Before installation, the pipeline and ancillary equipment should be thoroughly cleaned to quickly remove metal materials, residual tape, rust, etc.. If cleaning is not possible, install a filter in front of the valve.

(3) During installation, condensate, residue, etc. should be avoided to accumulate in the valve and care should be taken not to set the valve at the minimum, otherwise it will cause safety accidents.

(4)In order to ensure normal operation, please see if you have purchased the domestic automotive carbon steel one-way solenoid valve that you need, after installation is complete, it should be tested several times before it is officially put into operation.

(5) operation, should pay attention to the valve before, after, left, right pressure, do not exceed the rated pressure, in the lower working pressure, the working pressure in the pipeline than the minimum pressure, in case of vacuum solenoid valve position failure. When the pressure is higher than the level or above the level, close or reduce the pressure of the system.

(6) In daily use, the waste inside the check valve door should be cleaned up in time. Such as: screw cap, valve plug, transformer core, transformer core, transformer core, transformer core, transformer core, etc. Hydraulic pressure one-way solenoid valve should be careful to prevent damage.

(7) one-way solenoid valve is a kind of heat-conducting oil with high temperature, when removed from the pipeline, the valve body must be cleaned inside first, then squeezed and dried with air. When disassembled, each part should be placed in order, and then assembled.

(8) Each time you open the one-way solenoid valve, you must first clean the steam in the steam, steam, etc., and then test it several times until the state is stable, before putting it into use. If you do not use the vacuum solenoid valve of high-temperature heat-conducting oil for a long time, the front and rear and left and right valves should all be closed.