MHC2-16D finger cylinder

Operating temperature: 10~60℃

Repeat accuracy: Other

Working pressure: 0.1~0.6MPa

Product type: 2 jaws

Cylinder diameter: 16

Action mode: double-acting

Finger cylinder is also called as double-clamp cylinder, is to add a method and effect to its own function, but the main role can still achieve a variety of climbing function, is an important part of modern pneumatic manipulator. Finger cylinder has the following characteristics.

1. all structures are dual-functional, can achieve two climbs, can be automatically aligned, repeat high precision.

2. stable climbing torque.

3. magnetic coupled rodless cylinder can place the contactless stroke check power switch on both sides of the cylinder.

4. There are different kinds of installation . Interface.

5. Reduce air consumption.

Air finger cylinder has three common methods.

1. such as swinging finger cylinder, there is a cross shaft pin on the cross bar of the hydraulic cylinder, because the shaft of the finger is connected to the cross shaft pin, so the finger can move and completely automatically centered, and maintain the stability from the beginning to the end.

2. The small finger cylinder rotates the finger cylinder in essentially the same way as the rack and pinion. The fingers touch an actuator which accelerates the actuator and pushes the fingers onto the rotation. 2 fingers can be rotated additionally and are fully auto-centered, ensuring that the crawling torque is stable from start to finish.

3. as shown in the figure, is a parallel surface shaped finger cylinder with a cross shaft pin on the cylinder, which is connected to the cross shaft pin, thus allowing parallel surface movement of the fingers. 2 pulling forks are connected to the same cross shaft pin, ensuring that it can move again and achieve auto-centering.